How To Use; Power Switch - Eureka 96 Owner's Manual

O
AA
10
ENGLISH
HOW TO ASSEMBLE
Charge the Batteries
Note: Charge the batteries for 14-16 hours before
initial use. A cleaner may lose charge in
shipment. The charger plug will become warm,
however this is not a cause for concern.
Note: If the batteries are completely void of charge, the
charging light may not shine until there is
sufficient charge in the batteries to provide power.
Step 1: Turn the nozzle
the bracket I (Fig. 5) or remove the battery from the
AA
cleaner and place battery in charging stand.
Step 2: Charge light J blinks while charging. It will stopblink-
AA
ing when charge is complete. Charge light
there is power to the unit/charger.
It is all right to leave the cleaner on constant charge so it is
always ready to use. Unplug only if it will not be in use for
several weeks at a time.
Note: You can charge a battery in the unit and an extra
battery (optional) at the same time.

HOW TO USE

Power Switch

Note: On initial use, the clear plastic shipping switch
lock must be removed to activate the switch.
Pull on tab to remove.
Step 1: Push the power switch
turn off.
Step 2: Select type of cleaning. Carpet cleaning starts the
brush roll turning. Bare floor cleaning stops the brush
roll (Fig. 6).
Step 3: To use on bare floors or area rugs, make sure that
handle G is attached to the cleaner body (Fig. 7).
AA
Step 4: To use as a handvac remove handle
releasing the lock button
(continued)
O down and lower the cleaner onto
AA
N down to turn on; push up to
AA
by
G
AA
M (Fig. 8).
AA
K shows
AA