Adjusting The Feed Regulator - Consew 206RBL-18 Operating Instructions & Parts Book

8-13. Adjusting the feed regulator
=
~
6)
6
eo([)
ill
~
0
I
e
o ([)
ill
__
--~r--------------
If the stitch length of forward and reverse are not
same,make adjustment of feed regulator.
1. Remove the arm rear cover plate
O.
2. Turn the cover plate
0 ,
loosen the screw
0
with
holding upward the reverse lever.
3. When the mark of feed regulator
e
and feed
regulator rod () are alignment, stitch length of
forward and reverse will be same.
4. Turn leed regulator rod () to the arrow "X", stitch
length of reverse is bigger and stitch length of
forward is smaller.
5. Turn feed regulator rod
0
to the arrow "Y" ,stitch
length of reverse is smaller and stitch length of
forward is bigger.
6. Alter adjustment,liglhen the screw
0 .