Work Table And Motor - Consew 206RBL-18 Operating Instructions & Parts Book

3.
WORK TABLE AND MOTOR
.. Work Table
• When using a table made by another manufacturer, drill holes in the table as shown in the figure below .
• The top of the table should be 40 mm in thickness and should be strong enough to hold the weight and
withstand the vibration of the sewing machine.
Work table processing diagram
-IK-I-"
Head rest hole
Motor mounting holes
026 Sea! depth 1
Knee lifter installation
position
81
~'or.;: l
Thread sland hille
51%0.3
+
+
+
>:::'f-t---T---+-+---l-+--T-----f',=t
4-2511
~
.
JC===================t====~====±=~~±===============~-~ ~
~~~-------------------------7~1200----------------------------,1
A-A cross section
B-B
cross section
Oil pan installation pos~ion
15.5mm
.. Motor
ACAUTION
w
8
40
All cords which are connected to the motor
should be secured at least 25 mm away from
any moving parts. Furthermore, do not ex-
cessively bend the cords or secure them too
firmly with staples, otherwise there is the
danger that fire or electric shocks could oc-
cur.
O ·
Install the correct belt guard which corre-
sponds to the motor being used.
<Motor>
• Select the correct motor from those listed in the table.
• Refer to the instruction manual for the motor for de-
tails on installing and using the motor.
<Motor pulley
and
V-belt>
• Select the correct motor pulley and V·belt
by referring to the table to suit the power
frequency of your area.
Sewing speed
2,000 spm
Power Motor
Single-phase 110V 2pole, 400W motor
Three-phase 220V 2pole, 400W motor
Frequency Motor pulley V-belt
50 Hz Motor pulley 55 41 inches
60 Hz Molor pulley 45 41 inches