2. Adjusting The Height Of The Feed Dog; 3. Adjusting The Feed Dog Posi~Ion (Longitudinal) - Consew 206RBL-18 Operating Instructions & Parts Book

8-2. Adjusting the height of the feed dog
The maximum height of the feed dog
0
from the sur·
face of the needle plate
6
is normally 1 mm. To ad-
just the height of the feed dog:
1. Tilt the machine head away from you. Turn the
pulley to raise the feed dog
0
to its highest posi-
tion.
2. Loosen the screw
8.
3. Raise or lower the feed dog
0
as necessary.
4. Tighten the screw
8.
8-3. Adjusting the feed dog position (longitudinal)
31.5mm
1. Change the feed amount to the smallest possible
setting.
2. Turn the pulley to raise the feed dog
0
to its high-
est position.
3. Tilt the machine head away from you.
4. Loosen the screw
6,
and then move the feed rock
shaft crank
8
to adjust so that there is a distance
of
31.5mml
from the edge of the needle plate
0
to the center of the needle hole on the feed dog
O.
5. Securely tighten the screw
8.