Adjusting The Timing Of The Vibrating Presser Foot - Consew 206RBL-18 Operating Instructions & Parts Book

8-12. Adjusting the timing of the vibrating presser foot
<When the needle lowers>
\
Feed dog
<When the needle raises>
lifting
presserfoot\.,~_i
t
Needle
lifting
presser
1001
vibrating
presser
fool
Needle
vibrating
pre;Ssss.e3irTo;~S~~~~~~~::riZ
Feed dog
o
0
o
0
Check the vibrating presser foot timing as follows:
1. Lower the presser bar lifter lever. then turn the
pulley toward you. At this time. the vibrating
presser foot should reach the feed dog before the
needle eye does.
2. When the needle is raised. make sure the vibrat-
ing presser foot is still holding the material firmly.
If the vibrating presser foot rises while the needle
is still penetrating the mater'af.
It
may cause .e
skipped stitches. etc.
cause
If the timing is not correct after you make these ad-
justments:
1. Loosen the two screws
O.
2. To synchronize the timing of the vibrating presser
foot. turn the cam
O.
3. Tighten the screws
O.