Table of Contents
Advertisement
2
Oil reservoir
3
Hand wheel
4
A
B
1 5m m
9. 8 N
Motor pulley
4. Installing the oil pot (Fig. 2)
1.Install the bolt ①, oil seal ② and spacer ③ onto the
oil reservoir, and then put the cushion ⑤ and spacer ⑧
into the set screw ④, then set it by nut ⑥.
2.Tighten the oil pot ⑦ onto the bolt ①.
5. Adjusting the tension of the belt (Fig.3)
When adjusting the tension of the belt, please
adjust the height of the motor, and press down the middle
of the belt with the force of 9.8N. There should be a slack
of 15mm.
Note: Please turn off the motor before adjustment.
6. Installing the belt cover (Fig.4)
1.Tighten the column ⑦ into the screw hole on the
machine head.
2.Install the belt cover (right) ① on the machine
head by set screw ② and ⑧.
3.Connect the belt cover (left) ③ to the claw AB of
the belt cover (right) ①.
4.Tighten the belt cover (left) ③ by set screws ④, ⑤
and ⑥.
Note: After installing the belt cover, make sure that
the belt cover is not touch with the belt and hand wheel.
2
Advertisement
Table of Contents
