Information For Adjustment; Adjusting The Qeight Of The Feed Dog; Relative Position Of The Feeder To Needle Plate - Consew 226R Operating Instructions Manual

:
I
.;J
I
. l
- ~ .. ~ ., .,..., ..
-. . ..
11
INFORMATION FOR ADJUSTMENT
ADJUSTING THE HEIGHT OF THE FEED DOG
The maximum
height of the feed dog
(CD,
Fig. 14)from thesurfaceof theneedle
plate (@, Fig. 14) is normally 1mm.
To adjust this height:
1. Lay down the machine head
toward the other side, and
turn the machine pulley so
as to raise the feed dog to
its highest point.
110
2. Loosen bell crank screw (F,
Fig. 5) and adjust the
height of the feeder by
raising or lowering it.
3. Securely tighten the screw
upon completion of
adjustment.
RELATIVE POSITION OF THE FEEDER TO NEEDLE PLATE
1. Place the feed regulating dial (@, Fig. 12) on the minimum position.
2. Turn the machine pulley so as to raise the feed dog to its highest point.
3. Lay down the machine head
toward the other side, and
loosen the screw (I, Fig. 5)
4. Adjust to be 32.1mm from
the edge of the needle plate
to the center of the needle
hole on the feed dog
(see Fig. 15)
5. Securely tighten the screw.
Imm
Fig. 14
@Needle
plate
32.1mm
Fig. 15