6. Installing The Belt; 7. Installing The Bobbin Winder - Consew 206RBL-18 Operating Instructions & Parts Book

4. INSTALLATION
4-6. Installing the belt
15-20mm
4-7. Installing the bobbin winder
1. Remove the screw
0
and remove the belt guard
'upper cover
8.
2. Tilt back the machine head, and then place the belt
o
onto the motor pulley and the machine pulley.
3. Turn the nut
0
to adjust so that there is 15·20 mm
of deflection in the belt €)
when it is pressed with
a finger with a force of 9.8 N (1 kgf).
4. Insert the belt guard upper cover
8
into the belt
guard
0
from above the pulley, and then tighten
it with the screw
O.
1. Push down the bobbin set lever
0
as far as it will
go.
2. Place the bobbin winder pulley
8
so that it pushes
the belt
0
by approximately 5 mm, and then place
the bobbin winder
0
sO that it is parallel with the
belt no Ie in the work table.
3. Install the bobbin winder
0
to the work table with
the two screws
0.
4. Pull the bobbin set lever
0
back and check that
there is approximately 5 mm of clearance between
the bobbin winder pulley
8
and the belt
0.