11. Adjusting The Presser Foot Movement Amount - Consew 206RBL-18 Operating Instructions & Parts Book

8-11.Adjusting the presser foot movement amount
Movement amount for
lifting presser foot
Movement amount for
vibrating presser foot
o
0
o
0
• Vibrating presser foot
0
and lifting presser foot f)
move up and down alternately.
• Normally, vibrating presser foot
0
and lifting
presser foot f) operate to the same height in their
vertical motions .
• The maximum height of vibrating presser foot
0
and lifting presser foot f) is 5.0 mm.
If changing the movement amounts of both the lifting
presser foot and vibratin g presser foot simultaneously,
use method {AI; if increasing the movement amount
for only one (thereby decreasing the movement of the
other), use method (8).
Method (A): Simultaneous adjustment of the move-
ment amount for both the lifting presser foot and vi-
brating presser foot
1. Loosen nut
e.
2. Move nut
e
up or down as suitable to the work.
(Raise the nut
e
for increasing motion; or lower it
for decreasing motion.)
3. Tighten the nut
e.
Method (B): Adjustment of the movement amount
for the vibrating presser foot
1. Loosen the vibrating presser bar screw
0
and
lower the presser bar lifter
0.
2. While holding the vibrating presser foot
0,
loosen
the bolt
0
and then move the presser foot 4) up
or down as necessary.
3. After positioning the vibrating presser foot
0,
tighten the bolt
0.
4. Tighten the vibrating presser bar screw
O.