Detaching And Refitting The Rails; Folding Down The Grill Element; Removing And Installing The Door Panels - Siemens HB36LB.60 Instruction Manual

Detaching and refitting the rails

The rails can be removed for cleaning. The oven must have
cooled down.
Detaching the rails
Lift up the front of the rail
1.
and unhook it (figure A).
2.
Then pull the whole rail forward
3.
and remove it (Fig. B).
4.
$


Clean the rails with cleaning agent and a sponge. For stubborn
deposits of dirt, use a brush.
Refitting the rails
First insert the rail into the rear socket, press it to the back
1.
slightly (figure A),
and then hook it into the front socket (figure B).
2.
$
The rails fit both the left and right sides. The kinked section
must always be at the bottom.

Folding down the grill element

The grill element can be folded down for cleaning.
ã=
Risk of burns!
The oven must be cold.
Pull the handle on the folding grill towards you and push it
1.
upwards until you hear it click into place (figure A).
At the same time, take hold of the grill element and fold it
2.
down (figure B).
$
After cleaning, fold the grill element back up. Push the handle
down until the grill element clicks into place.
16
%


%
%

Removing and installing the door panels

To facilitate cleaning, you can remove the glass panels from the
oven door.
When removing the inner panels, pay attention to the order in
which the panels are removed. In order to reassemble the
panels in the correct sequence, follow the number which
appears on each panel.
The oven door may open either to the left or to the right,
depending on the appliance model.
Removal and installation instructions for the door panels apply
to left and right-opening oven doors.
Removal
Open the oven door.
1.
Unscrew the cover at the top of the oven door. To do this,
2.
undo the left and right screws (fig. A). Hold the panel with
one hand.
Pull the top panel up and out (fig. B).
3.
$
Unscrew the retaining clips on the right and left and remove
4.
them (fig. C). Remove the middle panel.
&
Pull the lower panel diagonally upwards and out.
5.
Clean the panels with glass cleaner and a soft cloth.
Do not use sharp or abrasive materials or a glass scraper. This
may damage the glass.
%