Furuno TZTL12F Installation Manual page 50

3. HOW TO SET UP THE EQUIPMENT
Motion sensor menu
Note: Motion sensor setup is not required if [Fish Finder Source] in the [Sounder]
menu is set to [Internal].
When you tap [Transducer Setup] from the [Sounder] menu, the [Motion Sensor]
menu is shown beneath the [Transducer Setup] menu. If the satellite compass SC-30
or SC50/110 is connected, set the distance between the antenna unit (or sensor) of
the satellite compass and transducer (high and low if connected) here.
Menu item
[Motion Sensor Select the sensor connected to you NavNet TZtouch2 unit. [SC30],
Type]
[Antenna Posi- Set the distance from the antenna unit to the transducer in
tion Bow/Stern the bow-stern direction. If the transducer is located on the
HF (LF)] fore side, set a positive value.
[Antenna Posi- Set the distance from the transducer to the antenna unit in
tion Up/Down HF the vertical direction.
(LF)]
[Antenna Port/ Set the distance from the antenna unit to the transducer in
Starboard HF the port-starboard direction. If the transducer is located on
(LF)] the starboard side, set a positive value.
3-16
SC-30/50/110
HF Transducer HF Transducer
Up/Down Up/Down
LF Transducer LF Transducer
Description
Bow/Stern for HF Bow/Stern for HF
Port/Starboard for HF Port/Starboard for HF
Port/Starboard for LF Port/Starboard for LF
Bow/Stern for LF Bow/Stern for LF
Options
(setting range)
[SC50_SC110]
[-99.9] to [+99.9]
[-0.00] to [+99.9]
[-99.9] to [+99.9]