Furuno TZTL12F Installation Manual page 41

[Initial Setup] menu - [DATA DAMPING]
Menu item
[COG & SOG]
[Heading]
[Speed Through Water]
[Wind Speed & Angle]
[Rate of Turn]
[Initial Setup] menu - [FUSION]
Menu item
[Connect to Fusion]
[Fusion Auto Volume]
[Minimum Speed]
[Maximum Speed]
[Volume Increase]
[Initial Setup] menu - [BROWSER INSTALLATION]
Menu item
[FAX30 Browser]
[FA30 Browser]
[FA50 Browser]
[Initial Setup] menu (Other menu items)
Menu item
[Chart Master Device]
[System ID]
[IP Address]
[Quick Self Test]
[Certification Mark]
[ServiceMan]
[Event/Buzzer Port
Configuration]
[Event Input
Configuration]
[Reset Default
Settings]
Description
Set data damping time. The lower the setting
the faster the response to change.
Description
Connects to your Fusion equipment.
Set to [ON] to allow the NavNet TZtouch2
unit to control the FUSION volume. Volume
is adjusted according to vessel speed.
Set the minimum speed threshold. Exceed-
ing this speed activates volume auto control.
Set the maximum speed threshold.
Set the amount of extra volume to output
when the vessel reaches the [Maximum
Speed] setting.
Description
Show the Facsimile Receiver FAX-30 display.
Show the AIS Receiver FA-30 display.
Show the AIS Receiver FA-50 display.
Description
Set to [ON] to use this unit as the master, [OFF] to use this unit as a slave.
The system ID for this device within the network.
IP address for this unit within the network.
Displays various details regarding the TZtouch2 unit, radar and fish finder.
Displays relevant certification for this equipment.
Requires login password. Used by service personnel only.
These menu items are not used.
Reset the system to default settings.
3. HOW TO SET UP THE EQUIPMENT
Options (setting range)
0 to 59 (seconds)
Options (setting range)
[ON], [OFF]
0.0 (kn) to 98.9 (kn)
0.1 (kn) to 99.0 (kn)
10% to 50%
Option (setting range)
Option (setting range)
[OK], [Cancel]
3-7