Programmable Features - Spirit XT485 Owner's Manual

PROGRAMMABLE FEATURES

The treadmill offers nine factory preset-programs, two user defined programs and one
Manual program. Each preset program has a maximum speed level that is displayed when a
desired workout is chosen. The maximum speed that the particular program will achieve will
be displayed in the Speed window. Also included are two user programs (User 1 and User 2)
for custom workouts.
SELECT A PROGRAM
STEP 1: Press the desired Program (Hill, Fat Burn, Cardio,
Strength, or Interval) key to select the program. The display will
prompt you through the programming or you can just press Start to
begin the program with default values.
STEP 2: If Enter was pressed, the Message Center will now be
blinking a value, indicating your Age (default is 35). Entering your
correct age affects the heart rate Bar Graph Display and the Heart
Rate programs. Use the + or - keys to adjust, then press Enter. Your
age determines your recommended maximum heart rate. Since the
Bar Graph Display and the Heart Rate features are based on a
percentage of your maximum heart rate, it is important to enter the
correct age for these features to work properly.
STEP 3: The Message Center will now be blinking a value, indicating
your Body Weight (default is 150#). Entering the correct body weight
will affect the calorie count. Use the speed + or - keys to adjust, then
press Enter. A note about the Calorie display: No exercise machine
can give you an exact calorie count because there are too many
factors which determine exact calorie burn for a particular person.
Even if someone is the exact same body weight, age and height, their
calorie burn may be very different than yours. The Calorie display is
to be used as a reference only to monitor improvement from workout
to workout.
STEP 4: The Message Center will be blinking a value, indicating
Time (the default value is 30 minutes). You may use the speed + or -
keys to adjust the time. After adjusting, or to accept the default, press
Enter. (Note: You may press start at any time during the
programming to start the program).
STEP 5: The Message Center will now be blinking the preset top
speed of the selected program (3 mph or 5 kmph). Use the Speed +
or - keys to adjust, then press Enter. Each program has various speed
changes throughout; this allows you to limit the highest speed the
program can reach.
You are now done programming data and may press Start to begin your workout or Enter to
go back one level to change data entered in the programming phase.
Customer Service 1-888-707-1880
Email: customerservice@pincoffs.ca
20
Dyaco Canada Inc. 2013