Copy Of Safety Decal - Regency P121-NG10 Owners & Installation Manual

This is a copy of the label that accompanies each P121-10/
P131-10 Zero Clearance Direct Vent Gas Fireplace. We have
printed a copy of the contents here for your review. The safety
label is located on the front inside base of the unit, visible when
the bottom louver is open.
NOTE: Regency units are constantly being improved. Check
®
the label on the unit and if there is a difference, the label on
the unit is the correct one.
Listed: VENTED GAS FIREPLACE HEATER / FOYER AU GAZ À ÉVACUATION
Certified for/Certifi e pour: CANADA and U.S.A.
Certified to: CAN/CGA-2.17-M91(R2009)
Tested to: ANSI Z21.88-2014/ CSA 2.33-2014
4001172 MAY BE INSTALLED IN MANUFACTURED (MOBILE) HOMES AFTER FIRST SALE.
NATURAL GAS: Model/Modele: P121-NG10/ P131-NG10
L
Minimum supply pressure
5"
Manifold pressure high
3.8"
Manifold pressure low
1.1"
Orifice size
# 31
Minimum input
20,500 Btu/h
Maximum input
40,000 Btu/h
0-4500 ft/pi
Altitude
Model/Modele: P121-LP10/ P131-LP10
PROPANE:
Minimum supply pressure 12"
Manifold pressure high 11"
Manifold pressure low 2.9"
Orifice size # 50
Minimum input 20,600 Btu/h
Maximum input 39,000 Btu/h
Altitude 0-4500 ft/pi
Minimum Clearances to Combustibles / Degagement Minimum De Materiaux Combustibles
0" Clearance to combustibles from: Top, bottom, sides & rear of unit
Mantel Height from Base of Unit: Min. 39" (991mm)
Side Wall Clearance from Side Facing 0" (0mm)
(See Instruction Manual for Detailed Instructions)
VENTED GAS FIREPLACE HEATER -
AU GAZ À ÉVACUATION - NE PAS UTILISER AVEC DU COMBUSTIBLE SOLIDE.
Model:
P121-NG10
Modele:
Part #: 919-497
Colour: Black on grey, except for what is highlighted - print in red.
Size: 100% (Maximum width is 9")
For the State of Massachusetts, installation
and repair must be done by a plumber or
Material: 2 ml silver matt polyester (DPM SMS)
gasfitter licensed in the Commonwealth of
Massachusetts.
Nov. 24/2014: Created decal.
*Printer: Continue number sequence from 918-497 - do not restart at 0
For the State of Massachusetts, flexible
connectors shall not exceed 36 inches in
length.
For the State of Massachusetts, the appli-
ances individual manual shut-off must be a
t-handle type valve.
The State of Massachusetts requires the
installation of a carbon monoxide alarm in
accordance with NFPA 720 and a CO alarm
with battery back up in the same room where
the gas appliance is installed.
Copy of Safety Decal for P121/P131
é
APPAREIL FONCTIONNANT AU NATURAL GAZ
CONCU POUR ETRE POELE:
Pression d'allimentation minimum
WC (1.25 kPa)
Pression à la tubulure d' chappement lev e
WC (0.95 kPa)
Pression à la tubulure d' chappement basse
WC (0.27 kPa)
Grandeur de l'injecteur
DMS
D bit Calorifique minimum selon é
(6.01 kW)
D bit Calorifique maximum selon é
(11.72 kW)
(0-1372 m) l'altitude
APPAREIL FONCTIONNANT AU GAZ PROPANE
CONCU POUR ETRE POELE:
WC (3.00 kPa)
Pression d'allimentation minimum
WC (2.74 kPa)
Pression à la tubulure d' chappement lev e
WC (0.72 kPa)
Pression à la tubulure d' chappement basse
DMS
Grandeur de l'injecteur
(6.04 kW)
D bit Calorifique minimum selon é
(11.43 kW)
D bit Calorifique maximum selon é
(0-1372 m)
l'altitude
DOOR SEAL:Please check that the door is properly sealed
NOT FOR USE WITH SOLID FUELS. /
P131-NG10 P121-LP10
Duplicate S/N
DO NOT REMOVE THIS LABEL / NE PAS ENLEVER CETTE ÉTIQUETTE
This appliance must be installed in accordance with local codes, if any; if
none, follow the National Fuel Gas Code, ANSI Z223.1, or Natural Gas
and Propane Installation Code, CSA B149.1.
This appliance must be installed in accordance with the Standard CAN/CSA
é é é
Z240 MH, Mobile Housing, in Canada, or with the Manufactured Home
é
Construction and Safety Standard, Title 24 CFR, Part 3280, in the United
States, or when such a standard is not applicable, ANSI/NCSBCS
A225.1/NFPA 501A, Manufactured Home Installations Standard or ANSI
A119.2 ou NFPA 501C Standard for Recreational Vehicles
This appliance is only for use with the type of gas indicated on the rating plate
and may be installed in an aftermarket, permanently located, manufactured
(mobile) home where not prohibited by local codes. See owner's manual for
details. Optional Fan (Part # 910-171)
Installer l'appareil selon les codes ou règlements locaux, ou, en l'absence de
tels règlements, selon les codes d'installation ANSI Z223.1, National Fuel
é é é
Gas Code ou CSA-B149.1 en vigueur.
é
Installer l'appareil selon la norme CAN/CSA-Z240, Série MM, Maison
mobiles ou CAN/CSA-Z240 VC, Véhicules de camping, ou la norme 24 CFR
Part 3280, Manufactured Home Construction and Safety Standard. Si ces
normes ne sont pas pertinentes, utilisez la norme ANSI/NCSBCS
A225.1/NFPA 501A, Manufactured Home Installations Standard, ou ANSI
A119.2 ou NFPA 501C Standard for Recreational Vehicles.
Cet appareil doit être utilize uniquement avec le type de gaz indiqué sur la
Minimum Vent Clearances:
plaque signalétique. Cet appareil peut être installé dans une maison
préfabriquée ou mobile (É.-U. seulement) installée à demeure si les
Horizontal Top 2-1/2" (64mm)
règlements locaux le permettent. Voir la notice de l'utilisateur pour plus de
Horizontal Side 1-1/2" (38mm)
renseignements. Cet appareil ne peut pas être utilisé avec d'autres gaz sauf
Horizontal Bottom 1-1/2" (38mm)
si une trousse de conversion certifiée est fournie.
This vented gas fireplace heater is not for use with air filters.
Ne pas utiliser de filtre à air avec ce foyer au gaz à évacuation.
For use with glass doors certified with the appliance only.
Pour utilisation uniquement avec les portes en verre certifiées avec
FOYER
l'appareil.
For Use Only with Barrier (Part #363-000) Follow installation instructions.
Utiliser uniquement avec l'écran ( n ° 363-000)
Suivre les instructions d'installation.
ELECTRICAL SUPPLY/ALIMENTATION ELECTRIQUE:
P131-LP10
115V_60HZ less than/moins de 2 AMP
Made in Canada/ Fabrique au Canada
Regency P121-10/P131-10 Zero Clearance Direct Vent Gas Fireplace
®
safety decal
304
Serial No./ No de serie
304
|
5
919-497
| 5