Table of Contents
Advertisement
4000 Series Vandal Resistant Range
Surface mounting door station installation
C
Fig. 1
E
G
E
G
Fig. 3
1. To separate the panel
a screwdriver, then lever the panel from the bottom to extract it (Fig. 1);
2. Place the surface box
for the wall plugs and the hole for the cables (Fig. 2);
3. Drill the 4 fixing holes
(Fig. 3);
the screws
G
4. Connect the wires using a terminal screw driver then setup the dip-switches as per provided connection diagram or instruction
sheet, then power up the system and check that it works correctly (Fig. 4);
5. Insert the top end of the panel
Do not over tighten the screws more than necessary.
CUSTOMER SUPPORT
All Countries:
VIDEX ELECTRONICS S.P.A.
www.videx.it - technical@videx.it
Tel: +39 0734-631669
Fax: +39 0734-632475
Art. 4212V-4212RV - Installation instructions
A
C
D
F
D
B
Fig. 4
from the surface box
A
B
against the wall (165-170cm between the top of the box and the floor lever) and mark the 4 fixing holes
B
, insert the wall plugs
D
E
first, then level down and fix to the surface box
A
UK Customers:
VIDEX SECURITY LTD
www.videx-security.com
Tech Line: 0191 224 3174
Fax: 0191 224 1559
B
, first remove the two screws
and feed the cables
through the surface box, fix surface box to the wall using
F
20
B
Fig. 2
A
C
Fig. 5
located on the bottom of the surface box using
C
with the two screws
B
The product is CE marked demonstrating its conformity and is for distribu-
tion within all member states of the EU with no restrictions. This product
follows the provisions of the European Directives 2004/108/ECC (EMC);
2006/95/ECC (LVD) and 93/68/ECC (CE marking).
66250203-EN - V0.3 - 10/07/15
B
C
(Fig. 5).
C
Advertisement
Table of Contents
