Introduction; Dear Customer; Good Service; Serial Number - Husqvarna DXR300 Operator's Manual

Dear Customer,

Thank you for choosing a Husqvarna product!
This operator's manual is a valuable document. Make sure it
is always at hand at the work place. By following its
instructions (on operation, service, maintenance, etc.) you
will significantly extend the life of the machine and even its
second-hand value.

Good service

Husqvarna products are sold all over the world and ensures
that you, the customer, get the best support and service.
When you need spare parts or advice on service or warranty
issues, go to www.husqvarnacp.com and find your local
service agent.

Serial Number

The machine's serial number is given on the hydraulic tank
under the left top cover. Stated on the plate are:
• The machine's type designation
• Weight
• The manufacturer's type number
• The machine's serial number
• Manufacturer
The hydraulic pump and hydraulic motors are fitted with rating
plates that indicate article number and the machine
manufacturer's manufacture number.
Please state the type designation and serial number when
ordering spare parts and for service matters.

Applications

The machine is intended for:
• Demolishing, fragmenting, cutting, detaching, separating,
picking up and distributing parts of buildings and
constructions.
• Use in risky environments where the operator can control
the machine without being present within the risk area.
• Use both indoors and outdoors.
• Use in dangerous environments where the machine is
exposed to risk of collapse, hazardous substances, great
heat, etc.
The machine is NOT intended for:
• Use in areas classified as 'explosive".
• Use in water where the level risks damaging the
machine's equipment.
• Operation on a public highway.
• Use as a towing vehicle, means of transport or lifting
device.
• Use in environments where there is danger for the
operator or the life and health of people in the vicinity.
• Use in applications or environments that are not
compatible with the recommendations in this Operator's
Manual.

INTRODUCTION

User responsibility

It is the owner's/employer's responsibility that the operator
has sufficient knowledge about how to use the machine
safely. Supervisors and operators must have read and
understood the Operator's Manual. They must be aware of:
• The machine's safety instructions.
• The machine's range of applications and limitations.
• How the machine is to be used and maintained.
National legislation could regulate the use of this machine.
Find out what legislation is applicable in the place where you
work before you start using the machine.

The manufacturer's reservation

Husqvarna Construction Products reserves the right to alter
specifications and instructions for the machine without prior
notification. The machine may not be modified without the
manufacturer's written permission. If the machine is modified
after delivery from Husqvarna Construction Products and
without the manufacturer's written permission, it is the
owner's responsibility.
Modification can entail new risks for operators, the machine
and the surroundings. These can include impaired strength or
inadequate protection. It is the responsibility of the owner to
specify which alterations are going to be made and to contact
the supplier of the machine for approval before commencing
the modifications.
All information and all data in the Operator's Manual were
applicable at the time the Operator's Manual was sent to print.
Contact
Husqvarna Construction Products, Jons väg 19, SE-433 81
Göteborg, Sweden.
– 5
English