Service - Husqvarna DXR300 Operator's Manual

ADJUSTABLE
WORK
Select this when you want to work with a tool that is not a standard tool.
The value for oil pressure and oil flow can be adjusted from port A to B. Select which setting you would like to change with the
selection keys. Use the arrow keys to change the value.
The oil direction can either be one-way – with or without grease (e.g. when working with a breaker) or two-way – with or without
grease (e.g. when working with a crusher). Press the selection key to switch to another mode.

Service

WORKING LIGHT
SERVICE
Activates/shuts off the work lighting. Press the selection key to switch to another mode.
NOTICE! Can not be shut off during operation.
TRACK TENSION
SERVICE
Hold the selection key down to activate the track tension.
OIL REFIL
SERVICE
The oil level is read through the sight gauge on the hydraulic tank. Refilling is needed if the level is more than 1 cm below the max
mark.
Hold the selection key down to refill oil.
Use the sight gauge to check the oil level when refilling.
32 –
English
SETTINGS
Adjustable tool
Oil press. A-B: 200 bar
(30...250 bar)
ADJUSTABLE
Adjustable tool
Oil press. B-A: 150 bar
(30...250 bar)
Back
ON/OFF
WORKING LIGHT
TRACK TENSION
Activate
ON/OFF
Hold down
to activate
Back
OIL REFIL
Activate
ON/OFF
Hold down
to activate
Back
Adjustable tool
Oil flow A-B: 50 l/min
(5...65 l/min)
Adjustable tool
Oil flow B-A: 50 l/min
(5...65 l/min)
Adjustable tool
Oil DIRECTION A<=>B
No grease
xx °C xx bar
TRACK TENSION
OIL REFIL