Introduction; Dear Customer; Good Service; Serial Number - Husqvarna DXR140 Operator's Manual

Dear Customer,

Thank you for choosing a Husqvarna DXR 140!
This operator's manual is a valuable document. Make
sure it is always at hand at the work place. By following its
instructions (on operation, service, maintenance, etc.)
you will significantly extend the life of the machine and
even its second-hand value.

Good service

Husqvarna products are sold all over the world and
ensures that you, the customer, get the best support and
service. When you need spare parts or advice on service
or warranty issues, go to www.husqvarnacp.com and find
your local service agent.

Serial Number

The machine's serial number is indicated on the arm by
the mounting against the tower. Stated on the plate are:
• The machine's type designation
• Weight
• The manufacturer's type number
• The machine's serial number
• Manufacturer
The hydraulic pump and hydraulic motors are fitted with
rating plates that indicate article number and the machine
manufacturer's manufacture number.
Please state the type designation and serial number when
ordering spare parts and for service matters.

Applications

The machine is intended for:
• Demolishing, fragmenting, cutting, detaching,
separating, picking up and distributing parts of
buildings and constructions.
• Use in risky environments where the operator can
control the machine without being present within the
risk area.
• Use both indoors and outdoors.
• Use in dangerous environments where the machine is
exposed to risk of collapse, hazardous substances,
great heat, etc.
The machine is NOT intended for:
• Use in areas classified as "explosive".
• Use in water where the level risks damaging the
machine's equipment.
• Operation on a public highway.
• Use as a towing vehicle, means of transport or lifting
device.
• Use in environments where there is danger for the
operator or the life and health of people in the vicinity.
• Use in applications or environments that are not
compatible with the recommendations in this
Operator's Manual.
4 – English

INTRODUCTION

User responsibility

It is the owner's/employer's responsibility that the operator
has sufficient knowledge about how to use the machine
safely. Supervisors and operators must have read and
understood the Operator's Manual. They must be aware
of:
• The machine's safety instructions.
• The machine's range of applications and limitations.
• How the machine is to be used and maintained.
National legislation could regulate the use of this
machine. Find out what legislation is applicable in the
place where you work before you start using the machine.

The manufacturer's reservation

Husqvarna Construction Products reserves the right to
alter specifications and instructions for the machine
without prior notification. The machine may not be
modified without the manufacturer's written permission. If
the machine is modified after delivery from Husqvarna
Construction Products and without the manufacturer's
written permission, it is the owner's responsibility.
Modification can entail new risks for operators, the
machine and the surroundings. These can include
impaired strength or inadequate protection. It is the
responsibility of the owner to specify which alterations are
going to be made and to contact the supplier of the
machine for approval before commencing the
modifications.
All information and all data in the Operator's Manual were
applicable at the time the Operator's Manual was sent to
print.
Contact
Husqvarna Construction Products, Jons väg 19, SE-433
81 Göteborg, Sweden.