Circuit Breakers And Fuses - Chassis/Dash Automotive 12-Volt; Mountain Driving - Winnebago 2009 Adventurer Operator's Manual

Table of Contents

Advertisement

SECTION 3 –
DRIVING YOUR MOTOR HOME
Further Information
Refer to the chassis manual in your InfoCase
for further information.
CIRCUIT BREAKERS AND
FUSES – CHASSIS/DASH
AUTOMOTIVE 12-VOLT
The 12-volt automotive fuses and breakers are
conveniently located behind the panel beneath
the left end of the dash in front of the driver's
seat.
The circuit breakers will pop outward if they
are tripped. Simply push in to reset.
Always replace plug-in blade fuses with ones
of the same size and amperage rating/color.
See your chassis manual for further
information about chassis supplied fuses.
Automotive Fuse/Breaker Panel
(Located beneath left end of dash)
3-16

MOUNTAIN DRIVING

Special techniques must be used when driving
in mountainous or hilly country.
Climbing A Hill
The transmission will automatically
downshift as needed to climb most hills. If the
hill is long or very steep, however, you may need
to manually shift to a lower gear to keep the
transmission from repeatedly upshifting and
downshifting. Select the lowest adequate gear
range for the duration of the incline. See your
chassis manual for specific information.
Descending A Hill
When going down a long grade, you may need
to manually shift to a lower gear rather than
keeping your foot on the brake pedal. A lower
gear will allow the engine to provide a degree of
braking action. Holding your foot on the brake
pedal for an extended period may cause brakes to
overheat, which could cause brake failure. See
your chassis manual for specific information.
NOTE: Workhorse
chassis 20,700 GVWR or
higher should use grade brake in
mountain driving.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents