Winnebago 2009 Adventurer Operator's Manual page 114

SECTION 10 –
SLIDEOUT ROOMS AND LEVELING
• Insert the Safety Lock key and turn to activate
slideout room control switch.
• Press the Slideout Room "EXTEND/OUT"
switch and hold until the room is fully
extended, then release the switch.
• To stop extending the room during operation,
release the button.
• Deactivate the slideout switch with the Safety
Lock key.
To Retract Slideout Room
Before Retracting!
• Be sure the coach is level and the Parking
Brake is set.
• Check inside and outside the vehicle to make
sure that there are no people who could be
harmed or obstacles that could cause damage
due to room retraction.
• If the slideout room has a couch or other
furniture, make sure no people or pets are
seated on them until the room has been fully
retracted.
• Remove all items from the coach living room
floor and close cabinet doors and drawers. Be
sure there are no items at the end of the bed,
behind the driver seat, or protruding from
compartments, which could be crushed or
cause damage to floor covering or cabinets
when the room is retracted.
CAUTION
Because the slideout roof is drawn into
the interior of the coach when retracted,
be sure there is no debris, such as
excessive dirt, tree seeds, twigs, leaves,
etc. on the roof before retracting.
If it has rained recently before you retract the
slideout room, we recommend using the
hydraulic leveling system (if equipped) to lean
the coach and drain off any excess water possibly
remaining on the roof before retracting. Lean the
coach slightly to the left (driver's side) as shown
10-4
by raising both right side jacks to let excess water
flow away from the rooftop weather seal and
toward the outside of the slideout roof. Retract
the slideout slowly, starting and stopping to allow
water to drain off room cover.
Retract Procedure:
See "Before Retracting!" before proceeding.
• Start the engine so the alternator can provide
maximum power for proper operation of
slideout mechanisms.
• Insert the Safety Lock key and turn to activate
slideout room control switch.
• Press the Slideout Room "RETRACT/IN"
switch and hold until the room is fully
retracted, then release the switch.
• To stop retracting the room during operation,
release the button.
• After the room is retracted, deactivate the
slideout switch with the Safety Lock key, then
refasten the travel lock or latch inside the
coach (if equipped).