Power Sunvisors; Brake-Shift Interlock; Parking Brake - Foot Pedal - Winnebago 2009 Adventurer Operator's Manual

SECTION 3 –
DRIVING YOUR MOTOR HOME
Basic Operating Instructions
Power - Turn ON to activate
monitor for rear viewing while
driving or parked. Key must be on.
In OFF (Standby) position the
monitor is "asleep" and will "wake
up" when the transmission is
shifted into Reverse.
Camera -
CA1= Rear or Side* cameras
CA2= Not used
Day/Night - Press to adjust
contrast and brightness for
nighttime and daytime lighting
conditions. After making
adjustments, button is used to
switch between settings.
Volume, contrast, and brightness
are self-explanatory.
*Sideview Cameras
–If Equipped
The optional sideview cameras allow you to
see what is beside you before turning or changing
lanes.
The sideview cameras activate with the
corresponding turn signals and replace the rear
camera view on the monitor until the turn is
completed or the signal lever is canceled
manually.
Further Information
See the rearview monitor manufacturer's
complete operating information in your
InfoCase.

POWER SUNVISORS

–If Equipped
The powered sunvisors are controlled by
switches on the driver and passenger armrest
panels.
• Press and hold the desired switch DOWN to
extend or UP to retract, then release at the
desired position.
• Driver side switches allow the driver full
control of all visors.
3-6
• Passenger side switch controls only the
passenger side visor.
NOTE: Do not position visors where they will
impair the driver's forward vision or side
mirror views.

BRAKE-SHIFT INTERLOCK

™
Workhorse and Ford
The brake-shift interlock is a safety feature
that prevents the shift lever from being moved
from the Park position unless the ignition is ON
and the service brake pedal is pressed.
NOTE: On Ford chassis, if the brake light fuse is
blown, the interlock feature will not work
properly and an alternate method must
be used. See your Ford Owners Guide for
detailed instructions on what to do in this
situation.
PARKING BRAKE – FOOT
PEDAL
Ford ® Chassis – All
Workhorse Chassis – 22,000 &
™
24,000 lbs. GVWR
The parking brake foot pedal and release lever
are located beneath the left side of the dash.
Step the pedal down fully to apply and pull the
brake release knob to disengage.
®
Chassis