Furuno FS-1575 Operator's Manual page 154

11. MAINTENANCE & TROUBLESHOOTING
Notification message
Scan group by that name does
not exist.
Scan group memory is full.
Channel by that number does
not exist.
Operation name already exists. The timer operation under this
Timer operation memory is full.
Device Access Error
File Write Error (Write Protect-
ing)
File Open Error (Already
Opened)
File Open Error (Max Open)
File Open Error (File not Found) The file does not exist.
File Open Error (File Exist)
SD Card Format failed.
File not found. '%s'
Card full.
Check interconnections be-
tween terminal and Main. Set
SMT for stand-alone use.
Cannot print. Check connection
between printer and terminal
Selected file is not macro.
Macro command error.
Wait one minute before calling
again after failed
OCCUPIED.
11-8
Meaning
The scan group under this
name does not exist.
The scan group memory is full.
The channel number does not
exist.
name has already existed.
The timer operation memory is
full.
The device access fails.
The writing on the file fails. The
file is write-protect status.
The file is already opened.
The number of the opened files
is over the specified number.
The file has already existed.
The format of the SD card fails. Check the SD card.
The file is not found. ('%s'
means the file name.)
The capacity of the SD card is
full.
Check the connection between
the terminal unit and the trans-
ceiver unit. Set the SMT for the
stand-alone use.
Can not print out. Check the
connection between the printer
and the terminal unit.
The selected file is not a macro
file.
The macro command is illegal.
When failing to call, wait a
minute before calling again. In
case of automatic disconnec-
tion because of no replay from
the called party during calling in
the ARQ mode, can not call
again for a minute.
The transceiver unit has priori-
ty.
Remedy
Check the scan group name.
Delete unnecessary scan
groups.
Check the channel number.
Change the timer operation
name.
Delete unnecessary timer oper-
ations.
The data can be corrupted be-
cause picking up the SD card
on access. Before picking up
the SD card, execute [Remove
SD Card] from the [File] menu.
Awake the write-protect for the
SD card.
-
Close an opened file.
Check the file name.
Change the file name.
Check the file name.
Change the SD card or delete
unnecessary files.
Check if the transceiver unit
turns on. Check the connction
between the terminal unit and
the transceiver unit. For the
stand-alone use for IB-585, set
the time in the [System] menu.
Check the connection between
the printer and the terminal unit.
Select a file with ".mcr" exten-
sion.
Check the macro command.
-
Can not operate the NBDP ter-
minal unit because of in opera-
tion of the transceiver unit.
Switch the transceiver unit to
the RT screen.