How To Register Id Codes; User Channels; How To Register User Channels - Furuno FS-1575 Operator's Manual

8. NBDP PREPARATIONS
8.1.2

How to register ID codes

1. Press the function key F5 then the 5,
6, 7 or 8 key for IB-585 to enter the
Group ID Code (4 or 5 digits), Group
ID Code (9 digits), Select ID Code (4
or 5 digits) or Select ID Code (9 dig-
its), respectively. (For IB-583, press
the function key F5 then the 6, 7, 8 or
9 key.)
2. Enter Group ID or Select ID then press the Enter key. A prompt asks for confir-
mation of the data.
3. If the ID is correct, press the Enter key. For final confirmation of the data, the
"Caution" shown in the illustration below appears.
4. If the ID is correct, press the Enter key again.
8.2

User Channels

The user channels can be used in scanning entry and station entry.
For IB-585, the user channels are set by the transceiver unit. See section 6.2. For IB-
583, the user channel list provides storage for up to 100 user channels, numbered 0 -
99. See the following paragraphs.
8.2.1

How to register user channels

1. Press the function key F5 then the 4 key to open the [User Channel Entry] screen.
2. If [Create] is not underlined, press the →, ↑ and Enter keys to underline it.
8-2
e l e c t I D E n t r y
e l e c t I D C o d e ( 4 / 5 )
1 2 3 4 5
C a u t i o n
C o n f i r m t h e ' C O D E ' b e f o r e p r e s s i n g E N T E R k e y .
Y o u c a n n o t c h a n g e t h e C O D E o n c e i t h a s b e e n e n t e r e d .
Message for confirmation of code entered
s e r C h a n n e l E n t r y
C h a n n e l L i s t
C h a n n e l S e t p
Channel
:
T x F r e q :
R x F r e q :
e l e c t I D E n t r y
e l e c t I D C o d e ( 4 / 5 )
_
O K
C a n c e l
C r e a t e
C h a n g e
0 . 0 0
0 . 0 0