Displaying The Picture - Sony JJTRON ADN-8118 Operating Instructions Manual

Displaying the Picture

STATUS ON/OFF keys
MUTING PIC key
INPUT INPUT
A B
4
SCREEN BRIGHT
+ –
5
6
WIDESCREEN
MODE
POWER ON STANDBY
2
9
Control panel
LIGHT
MUTING STATUS
PIC AUDIO OFF
COLOR
6 MATRIX
WIDE SCREEN MODE
STANDARD FULL
INPUT SELECT
INPUT A INPUT B
RGB
4 VIDEO YUV
1
Raise the breaker at the rear of the unit.
The STANDBY button on the control panel lights in red and the unit
goes into the standby mode.
2
Press the ON key on the Remote Commander, or press and hold the
POWER ON button on the unit for more than 2 seconds.
The unit is turned on and the POWER ON button lights in green.
The picture appears about 10 seconds later.
3
Turn on the power of the connected equipment.
4
Press the INPUT SELECT keys on the Remote Commander or the
INPUT A or INPUT B button on the unit repeatedly to select the input
source.
INPUT A RGB key or INPUT A button: to watch the RGB signal
input from the equipment connected to the INPUT A connectors.
INPUT B VIDEO key: to watch the video signal input from the
equipment connected to the VIDEO connector when the BKJ-100
JJTRON Accessory Board (not supplied) is installed.
INPUT B YUV key: to watch the component signal input from the
equipment connected to the R/R-Y, G/Y and B/B-Y connectors
when the BKJ-100 JJTRON Accessory Board (not supplied) is
installed.
INPUT B RGB key: to watch the RGB signal input from the
equipment connected to the R/R-Y, G/Y, B/B-Y, HD/COMP and
VD connectors when the BKJ-100 JJTRON Accessory Board (not
supplied) is installed.
COMMAND
ON OFF ON STANDBY
ZOOM
SIZE SHIFT MEMORY
ZOOM
RGB RESET FUNCTION
PICTURE CONTROL
CONTR
BRIGHT
SHARP HUE COLOR
Remote Commander
9
2
ON
7
MENU
7
ENTER
SCREEN
BRIGHT
5
8
VOLUME
(continued)
17
(GB)