To remove the component:
Power down the server (on page 20).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 20).
o
Remove the server from the rack (on page 22).
o
Remove the access panel (on page 24).
4.
If a full-length expansion board is installed on a PCI riser cage, remove the riser cage
5.
riser
cages" on page 26).
Remove the air baffle.
6.
Install the air baffle
CAUTION:
expansion slot covers, or blanks installed. If the server supports hot-plug components, minimize
the amount of time the access panel is open.
For proper cooling, do not operate the server without the access panel, baffles,
("Remove the PCI
Operations 30