HP ProLiant DL180 Gen9 User Manual page 60

Do one of the following:
3.
Extend the server from the rack (on page 20).
o
Remove the server from the rack (on page 22).
o
Remove the access panel (on page 24).
4.
Remove the primary PCI riser cage
5.
If the 8-bay LFF hot-plug drive cage is currently connected to an HBA, remove the HBA from the primary
6.
PCI riser cage.
If the 8-bay LFF hot-plug drive cage is currently connected to the Mini-SAS connectors on the system
7.
board, do the following:
Disconnect the existing Mini-SAS cables from the drive backplane and the Mini-SAS connectors on
a.
the system board.
Release the Mini-SAS cables from the right front chassis cable clip.
b.
Install the storage controller:
8.
("Remove the PCI riser cages" on page 26).
Hardware options installation 60