Extend-Ip Acl - TP-Link JetStream T1600G-28TS User Manual

12.1.5 Extend-IP ACL

Extend-IP ACLs analyze and process data packets based on a series of match conditions, which
can be the source IP addresses, destination IP addresses, IP protocol and other information of this
sort carried in the packets.
Choose the menu ACL→ACL Config→Extend-IP ACL to load the following page.
The following entries are displayed on this screen:
Create Extend-IP ACL

ACL ID:
Rule ID:
Operation:
S-IP:
D-IP:
Mask:
IP Protocol:
S-Port:
D-Port:
Figure 12-5 Create Extend-IP Rule
Select the desired Extend-IP ACL for configuration.
Enter the rule ID.
Select the operation for the switch to process packets which match the
rules.
Permit: Forward packets.

Deny: Discard Packets.

Enter the source IP address contained in the rule.
Enter the destination IP address contained in the rule.
Enter IP address mask. If it is set to 1, it must strictly match the
address.
Select IP protocol contained in the rule.
Configure TCP/IP source port contained in the rule when TCP/UDP is
selected from the pull-down list of IP Protocol.
Configure TCP/IP destination port contained in the rule when
TCP/UDP is selected from the pull-down list of IP Protocol.
176