Operation
Reset
This setting allows you to reset the COLORado™ 2-Quad Zoom IP to the default values,
including the custom programs.
1. Go to the SET main level.
2. Select REST, press <ENTER>.
3. Enter the master access passcode as described in Passcode.
4. Wait for the reset process to finish.
Whites Setting
This setting allows you to select and edit the temperature of the white colors used in channel 6
(Macros) when in the TOUR mode, or channel 11 (Macros) when in the TR16 or STD.Y mode.
1. Go to the CAL main level.
2. When PASS shows, press <ENTER>.
3. Enter the master access passcode as described in Passcode.
4. Go to CAL.
5. Go to WT and select a white color (WH.01–11).
6. Select a color (R., G., B., or W.).
7. Select a color value (000–255).
8. Repeat for the other colors.
White Calibration
This setting allows you to select the white color shown by the COLORado™ 2-Quad Zoom IP
when the color setting is RGBW and the DMX controller's red, green, and blue faders are set to
255.
1. Go to the CAL main level.
2. When PASS shows, press <ENTER>.
3. Enter the master access passcode as described in Passcode.
4. Go to CAL > RGBW > RGB.W.
5. Select a color (R., G., or B.).
6. Select a color value (000–255).
7. Repeat for the other colors.
When selecting CAL > PASS > CAL> RGBW > RGB.W, you will only be able to define the
values of R. (red), G. (green), and B. (blue).
The values of R. (red), G. (green), and B. (blue) configured from CAL > PASS > CAL>
RGBW > RGB.W will define the color temperature shown when the RGB faders are set to
255 if SET > COLR > RGB.W is active.
Static Color
The Static Color mode allows for permanent RGBW color mixing without a DMX controller.
1. Go to the STAT main level.
2. Select the desired color (R., G., B., or W.).
3. Select the desired color value (000–255).
4. Repeat for the other colors.
5. Select Z..
6. Select the beam angle value (000–255).
7. Select S..
8. Select the desired strobe frequency (00–20).
COLORado™ 2-Quad Zoom IP User Manual Rev. 3
-13-