Table of Contents
Advertisement
Operation
White sets the color temperature of the white produced when the DMX values of Red Green
White
and Blue are at 255 or 100%. To set the color temperature, do the following:
1. Go to the White main level.
2. Select the desired color (R, G, or B).
3. Select the desired color value (125–255).
4. Repeat the steps for each color
5. Press <MENU> to return to the home screen
Fan Speed
Fan Speed configures the fan for quiet operation. To configure the fan, do the following:
1. Go to the Fan Speed main level.
2. Select the desired speed (High or Auto).
Temperature shows the internal temperature of the Nexus™ 4x1. To show the internal
Temperature
temperature, do the following:
1. Go to the Temperature main level.
Reset to factory defaults clears all settings in the Nexus™ 4x1. Reset to Factory Defaults is
Reset To Factory
not a menu option. To reset the Nexus™ 4x1 to factory defaults, do the following:
Default
1. Disconnect the Nexus™ 4x1 from power.
2. Press and hold <MENU> and <ENTER> simultaneously.
3. Reconnect the Nexus™ 4x1 to power.
4. Release <MENU> and <ENTER> when Factory reset? ENTER = Confirm shows on the
display.
5. Press <ENTER>.
6. Wait for the reset process to finish.
The Nexus™ 4x1 panels run on Kling-Net or Art-Net.
Setting Ethernet
Protocols
The Kling-Net protocol requires no configuration, except to set the Nexus™ 4x1 to Kling-Net.
All Ethernet configurations in the Kling-Net protocol are done automatically by ArKaos
MedaiMaster™.
The Art-Net protocol requires configuration of a number of Ethernet settings. .For more
information, see Art-Net™.
Kling-Net
To set the Nexus™ 4x1 to Kling-Net, do the following:
1. Press <MENU> and then <DOWN>. Ethernet Settings shows in the display.
2. Press <ENTER>.
3. If <Kling-Net> shows in the display, Press <MENU> until display return to the home
The Kling-net protocol is set.
If <Art-Net> shows in the display, do the following:
4. Press <ENTER>. The words <Art-Net> start blinking.
5. Press <UP> or <DOWN>. <Kling-Net> shows and is blinking.
6. Press <ENTER>. The words <Kling-Net> stop blinking.
7. Press <MENU> untitl display return to the home
The Kling-Net protocol is set.
Nexus™ 4x1 User Manual Rev. 3
-19-
Advertisement
Table of Contents
