Setting Autocutter Type - Epson TM-L90 Developer's Manual

Confidential

Setting Autocutter Type

Users may choose between "Partial Cut" and "Full Cut" by adjusting the cutter unit to the
desired dowel position. The steps below show the setting of the cut type.
Note:
To disable the autocutter, change the memory switch setting (Msw 2-2).
When the cutting type is changed from partial cut to full cut, the cutter unit and the fixed blade must be
replaced with a new one since the ends of the blade are worn even though they have not been used.
The Partial Cut and Full Cut methods cannot be selected using switches or software commands.
Setting procedure
1. Turn off the power supply and open the paper roll cover.
2. Push the body case outward (in the direction of 2 arrows) and remove the cutter cover.
3. Remove the single screw retaining the cutter unit and loose a screw which is indicated by a
circle in the illustration below.
s crew
2-12 Setup
cutter cover
Loose a screw
Cutter unit
Rev. A