Printer Setup And Initial Settings; Setup Flow - Epson TM-L90 Developer's Manual

Confidential

Printer Setup and Initial Settings

Setup Flow

This section describes the initial setting of the printer available for an application. The initial
setting can be set up mechanically, by using DIP switches, or memory switches.
• Mechanism
2-6 Setup
Autocutter (See page 2-12)
• Full cut/ Partial cut
Note: Disabling or enabling of
the autocutter can be set by
Msw 2-2.
Adjust Near End Detector (See page 1-6)
• 36 and 41 (mm)
Paper Roll Width (See page 2-14)
• 38/39....79/80 (mm)
Note: Memory switch (customized
value) also needs to be set at the
same time.
Rev. A