Wiper Blades; Emission-Control System Maintenance - Mitsubishi ECLIPSE 2011 User Manual

Wiper blades

Check the wiper blades occasionally. Clean them regularly to
remove deposits of salt and road film. Use a sponge or cloth
and a mild detergent or non-abrasive cleaner to clean the blades
and glass areas.
Replace the blades if they continue to streak or smear.
NOTE
Do not run the wipers on dry glass for a long time. This
wears out the rubber and can scratch the glass.
During cold weather
If the blades are frozen to the windshield or rear window, do
not operate the wipers until the ice has melted and the blades
are freed, otherwise the wiper motor may be damaged.

Emission-control system maintenance

N00940700011
Your vehicle is equipped with an emission-control system that
meets all the requirements of the U.S. Environmental Protec-
tion Agency and Environment Canada. The emission-control
system is made of:
a positive crankcase ventilation system
an evaporative emission-control system
an exhaust emission-control system
The maintenance services listed in the "WARRANTY AND
MAINTENANCE MANUAL" must be performed at the times
or mileages listed to keep the emission-control system working
properly. These, and all the other "general" maintenance ser-
vices listed in this manual, need to be performed to keep your
vehicle running properly and reliably.
You may need more frequent maintenance if you drive your
vehicle in harsh conditions such as dusty areas or do a lot of
start-and-stop driving.
To be sure the emission-control system works properly, have
your vehicle inspected and maintained by an authorized
Mitsubishi Motors dealer or a repair facility of your choice fol-
lowing the schedule in the "WARRANTY AND MAINTE-
NANCE MANUAL".
You should also have an inspection and service any time you
suspect a malfunction.
I n f o r ma t i o n P r o v i d e d b y :
Vehicle care and maintenance
N00940800201
7-31
7