Mitsubishi ECLIPSE 2011 User Manual page 308

NOTE
If a problem is detected in the air conditioning compres-
sor, the air conditioning indicator light (A) blinks. Press
the air conditioning switch once to turn it off, then once
more to turn it back on. If the air conditioning indicator
light (A) does not blink, there is no problem. If it does
blink, have it checked at an authorized Mitsubishi Motors
dealer or a repair facility of your choice.
Sometimes, for example after using a high-pressure car
wash, the condenser can get wet, and the air conditioning
indicator light (A) blinks temporarily. In this case there is
nothing wrong. Wait for a while, press the air conditioning
switch once to turn the system off, then once more to turn
it back on. Once the water evaporates, the blinking will
stop.
Operating the air conditioning system (automatic
mode)
In normal conditions, use the system in the AUTO mode and
follow these procedures:
1. Set the blower speed selection dial to the "AUTO" posi-
tion.
2. Select the temperature control dial to the desired tempera-
ture. The temperature can be set within a range of around
61 to 89 (Type 1) or 18 to 32 (Type 2). The temperature
may be set higher by turning the dial to the right.
3. Set the mode selection dial to the "AUTO" position.
The vents (except "
blower speed, and ON/OFF of air conditioning will be con-
trolled automatically.
I n f o r ma t i o n P r o v i d e d b y :
Comfort controls
" and " "), recirculation/outside air,
N00731700257
5
5-19