Maintenance - Ozito OZJS400A Instruction Manual

MAINTENANCE

1. After each use, blow air through the tool housing to ensure it is free from all dust
particles that may build up. Build up of dust particles may cause the tool to
overheat and fail.
2. If the enclosure of the tool requires cleaning do not use solvents but a moist soft
cloth only. Never let any liquid get inside the tool; never immerse any part of the
tool into a liquid.
3. When the carbon brushes wear out the tool will spark and/or stop. The brushes are
a wearing component of the tool and should be replaced prior to the carbon
wearing out fully. Brushes will wear out after many uses but before they do take
the tool to an electrician or a power tool repairer for quick and low cost
replacement. Always replace both brushes at the same time.
Note: Ozito Industries will not be responsible for any damage or injuries caused by
the repair of the tool by an unauthorised person or by mishandling of the tool.
DESCRIPTION OF SYMBOLS
V Volts
~ Alternating current
spm Revolutions or
reciprocation per minute
Double insulated
Warning
Read instruction manual
Wear eye protection
Hz Hertz
W Watts
n
o No load speed
Regulator compliance mark
Maximum cutting cap
for timber
Wear ear protection
Wear face mask
11