Ozito OZJS400A Instruction Manual page 11

OPERATION (cont.)
Cutting Metal
Your jigsaw can be used for cutting light gauge ferrous sheet and non-ferrous
metals such as copper, brass, aluminium, etc. It is advisable when cutting sheet
metal to clamp a backing sheet of soft wood or plywood to the work as this will
enable you to obtain a clean cut without vibration and the possibility of tearing the
metal. Both metal and wood backing are sawn together. Do not force the cutting
blade into the metal as this will reduce the life of the blade and possibly damage
the motor. Cutting thin metal will take longer than cutting even a relatively thick
piece of wood, so do not be tempted to speed up the operation by forcing the
saw. Spread a thin film of oil along the proposed cutting line before commencing
to saw metal. Always select the right blade for the job.
Pocket and Round Cutting
When needing to start a cut from the centre of a work piece, drill a hole using a
12mm drill bit to allow the blade to pass through the hole in order to begin the
cut. When cutting tight curves reduce the speed of the saw.
10