Ozito OZJS400A Instruction Manual page 9

INSTALLATION (cont.)
Removing a blade
1. Before performing any adjustments ensure the tool has been switched off and
is disconnected from any power supply.
2. Turn the Jigsaw upside down, slide the dust shield towards the shoe and use
the hex key to loosen the two blade securing bolts.
3. Remove the blade through the gap in the shoe.
Adjusting the angle of the shoe
1. The shoe can be tilted to angles between 0º – 45º left or right so that you can
cut bevel angles in a work piece.
2. Before performing any adjustments ensure the tool has been switched off and
is disconnected from any power supply.
3. Turn the Jigsaw upside down and use the hex key to loosen the shoe locking
screws that secure the shoe (refer back to Fig. 4).
4. Slide the shoe backwards away from the blade.
5. Tilt the shoe between 0 and 45° left or right. Bevel
angles of 0, 15, 30 and 45° are marked on the bevel
scale (Fig. 6).
Once the angle has been set, slide the shoe forwards
again and tighten the shoe locking screws.
If an accurate bevel is required, it is best to check
the setting with a protractor or by making a trial cut
in a piece of scrap material and re-adjusting the
setting if necessary (Fig. 7).
8
Fig. 6
Fig. 7