Related Manuals for Ozito OZDB45JA
Summary of Contents for Ozito OZDB45JA
-
Page 1: Operating Instructions
DEMOLITION BREAKER 45 Joules MODEL NO. OZDB45JA OPERATING INSTRUCTIONS w w w. o z i t o . c o m . a u For our full range visit... - Page 2 SPECIFICATIONS - MODEL NO. OZDB45JA Motor: 1700w Input: 230V ~ 50Hz Impact energy: 45 joules Impacts: 1300 bpm Breaking capacity: 200mm concrete Bit capacity: 30mm round hex shank Tool length: 750mm (excluding bit) Weight: 18 kg Features Adjustable handle Quick release bit lock Soft grip rear handle Chisel &...
-
Page 3: Safety Instructions
The electric motor has bEen designed for 230 - 240V only. Always check that the power supply corresponds to the voltage on the rating plate. Note: The supply of 230V and 240V on Ozito tools are interchangeable for Australia and New Zealand. - Page 4 GENERAL 1. Keep work areas clean. Cluttered areas and benches can cause accidents. 2. Consider work area environment. Do not expose your tool to high humidity or rain. Do not use your tool in damp or wet conditions. Keep the work area well lit. Do not use your tool where there is a risk of causing fire or explosion, e.g.
- Page 5 22.Replacement of the supply cord. If the supply cord is damaged, it must be replaced by the manufacturer or an authorised Ozito Service Agent in order to avoid a hazard.
- Page 6 SAFETY INSTRUCTIONS FOR DEMOLITION BREAKERS Before breaking into walls, floors etc, ensure there are no concealed power cables or pipes in the cavity. Always use the front handle, this gives you greater control and ensures safe operation. Keep the cord clear of the accessory being used, do not wrap the cord around your arm or wrist.
- Page 7 OPERATION BEFORE ATTACHING OR REMOVING ANY ACCESSORIES BE SURE TO DISCONNECT THE DEMOLITION BREAKER FROM THE POWER SUPPLY Front Handle The front handle will provide additional control, support and guidance for the tool. The handle is adjustable to any position around the 360º handle collar mount.
- Page 8 OPERATION (cont.) 4. Lock the shank into the nose of the tool by pulling out the bit lock and rotating it 180°. 5. Pull the accessory to ensure the shank is properly secured into the nose of the tool prior to operation. 6.
- Page 9 Brushes will wear out after many uses but before they do take the tool to an Authorised Ozito Service Agent for quick and low cost replacement. Always replace both brushes at the same time.
- Page 10 CONTENTS 1 x Demolition Breaker OZDB45JA 1 x Tub of grease 1 x 40mm Flat chisel 1 x Allen key 1 x Point chisel 1 x Kit box 1 x Front handle 1 x Operation manual 1 x Front handle securing knob...
- Page 11 PURCHASED FROM:__________________________________________________ DATE PURCHASED: __________________________________________________ 1 YEAR REPLACEMENT WARRANTY Your Ozito tool is guaranteed for a period of 12 months from the original date of purchase and is intended for DIY (Do it yourself) use only. WARNING The following actions will result in the warranty being void.