Controls And Functions - Rear Panel - ADJ WiFly NE1 User Instructions

WiFly NE1
1. WIFLY ANTENNA - This is used to send WiFly wireless DMX signal to
compatible WiFly products.
2. EFFECT ROTARY KNOBS - These knobs are used to adjust fixture
channels and to adjust effect functions.
3. WIFLY INDICATOR - This LED will illuminate when a WiFly signal
enabled and active.
4. LCD DISPLAY - Displays all current functions and menu data.
5. DIAL/ENTER BUTTON - This dial is used to scroll through menu options
and confirm a selection by pressing it. It is also used to access manual
fixture control mode.
6. STROBE RATE FADER - This fader controls the shutter channel for fix-
tures that include a shutter channel.
7. USB PORT - This USB port is used to upload fixture profiles and
save/upload memory files. Supports most USB drives.
Note: USB stick can be formatted for FAT16 or FAT32.
Note: In order for your controller to recognize your files, they must be
stored in a folder named ADJ-NE1. The folder cannot have any other
name.
8. MASTER DIMMER FADER - This fader controls the master intensity,
typically tied into the dimmer channel of a fixture.
9. BLACKOUT BUTTON - Activates/Deactivates blackout state.
10. STROBE BUTTON - Press this button to activate/deactivate strobing for
selected fixtures.
11. MEMORY 1-6/7-12 BUTTONS - Used to save/playback memories (can
be static or moving scenes).
12. SET-UP BUTTON - This button is used to enter and exit the settings
menu.
13. ESC/PAGE - This button is used to exit the submenu. If you press and
hold this button for at least 3 seconds all output goes to zero. This but-
ton is also used to switch between memory button pages.
14. FUNCTION BUTTONS 1-12 - These buttons are multi-functional
depending on the selected mode.
15. MODE BUTTONS - These buttons are used to change the state of
operation. Note: The PAUSE button will only pause running effects.
ADJ Products, LLC www.adj.com - WiFly NE1
Controls and Functions
Page 8
WiFly NE1

Controls and Functions - Rear Panel

1. DMX OUT - Used to send DMX signal to the compatable LED fixtures.
2. DC INPUT - Accepts a DC12V, 500mA minimum, power supply
(Included).
3. POWER SWITCH - Use this switch to power on/off the controller.
WiFly NE1
Set Wifly Channel
1. Press the SET-UP button for two seconds to enter the main menu.
2. Turn the DIAL/ENTER button to menu option 6 (Set wifly channel).
Press the DIAL/ENTER button to enter.
3. Turn the DIAL/ENTER button to set the channel address (00 – 15),
then press the DIAL/ENTER button to confirm.
4. Press and hold the SET-UP button for 2 seconds to exit menu
mode.
Set Wifly Power
1. Press the SET-UP button for two seconds to enter the main menu.
2. Turn the DIAL/ENTER dial to menu option 7 (Set WiFly Power).
Press the DIAL/ENTER button to enter.
3. Turn the DIAL/ENTER dial to turn the WiFly power ON or OFF, then
press the DIAL/ENTER button to enter.
4. Press and hold the SET-UP button for 2 seconds to exit menu
mode.
ADJ Products, LLC www.adj.com - WiFly NE1
1 2 3
WiFly Set Up
Page 9