Kenmore W10686857A Use & Care Manual page 17

To turn cooling back on, press and hold both the MAX
COOL and MOISTURE CONTROL buttons, at the same time,
for 3 seconds. When cooling is on, "Cooling Off" will
disappear and the previously selected settings will appear
on the display screen.
Additional Features
Max Cool
The Max Cool feature assists during times of high refrigerator
use, full grocery loads or temporarily warm room temperatures.
Press MAX COOL to set the freezer and refrigerator to the
coldest temperature settings. Press MAX COOL again to
return to the selected temperature set point.
NOTES:
The Max Cool icon will be illuminated while the
refrigerator is in Max Cool mode. The displayed
compartment temperature settings will not change.
The Max Cool feature will turn off automatically after
24 hours.
Moisture Control
The moisture control feature turns on a heater to help reduce
moisture on the door hinge seal. Use in humid environments or
when you notice moisture on the door hinge seal. The
refrigerator uses more energy when Moisture Control is on.
To turn on the Moisture Control feature, press and hold
MOISTURE CONTROL for 3 seconds.
To turn off the Moisture Control feature, press and hold
MOISTURE CONTROL for 3 seconds.
Door Open Alarm
The Door Open icon lights up when a door has been open
for 5 minutes and cooling is on. An alert tone will sound
three times, and the Door Open icon will flash seven times.
This pattern will repeat every 2 minutes until all the doors
are closed completely. The feature then resets and will
reactivate when a door is left open again for 5 minutes.
NOTES:
To mute the audible alarm while keeping the doors open,
such as while cleaning the inside of the refrigerator,
press any button on the control panel. The alarm sound
will be temporarily turned off, but the Door Open icon
will still be displayed on the dispenser control panel.
All doors must be completely closed to turn off the Door
Open icon.
Sabbath Mode
Sabbath mode is designed for those whose religious
observances require turning off the lights.
In Sabbath Mode the temperature set points remain unchanged,
but the interior and dispenser lights turn off, all sounds and
alarms are disabled and the dispenser screen backlight turns
off.
To turn on Sabbath Mode, press and hold both FREEZER
TEMP and FRIDGE TEMP at the same time for 3 seconds.
After 3 seconds, an "engage" tone will sound and the icons
on the control panel display will flash and then disappear.
NOTE: You must close the doors to turn off the lights. The
lights will remain off while the refrigerator is in Sabbath
mode.
To turn off Sabbath Mode, press and hold both FREEZER
TEMP and FRIDGE TEMP at the same time for 3 seconds.
After 3 seconds, an "disengage" tone will sound and the
control panel will display the normal screen.
NOTE: After turning off Sabbath Mode, you must first close
the doors to turn ON the lights. Then the lights will function
normally.
NOTES:
Sabbath mode does not disable the water dispenser or the
ice maker. To turn off the ice maker, see "Ice Maker."
If a power failure occurs or you unplug the refrigerator while
it is in Sabbath mode, it will take 10 minutes for the cooling
system to resume when power is restored.
Water Filter Status Light and Reset
The filter reset control allows you to restart the water filter status
tracking feature each time you replace the water filter. See
"Water Filtration System."
Press and hold WATER FILTER for 3 seconds, to reset the
water filter status to Good. The Water Filter icon will turn
blue.
Air Filter Status Light and Reset
The filter reset control allows you to restart the air filter status
tracking feature each time you replace the air filter. See "Install
Air Filter."
Press and hold AIR FILTER for 3 seconds, to reset the air filter
status to Good. The Air Filter icon will turn blue.
17