Table of Contents
Advertisement
2. Press the TIME button (5) repeatedly until the desired programme duration is shown in
the display, e.g.
If the programme duration is not selected, the duration is automatically set to 10 min.
DELAY START
With the DELAY START button (7), you can delay the start of a programme by be-
tween 30 minutes (30') and a maximum of 20 hours (20h).
1. Select the programme and additional functions.
2. Press the DELAY START button (7) as many times as necessary until the required start
delay appears on the display, e.g.
If the display is showing 20h and you press the button again, the time delay will
be cancelled. The display will show 0'and then the duration of the selected pro-
gramme.
3. To activate the delay timer, press the START PAUSE button (6). The amount of time
remaining until the programme is set to start is continuously displayed (e.g. 15h, 14h,
13h, ... 30' etc).
Child lock
The child lock can be set to prevent a programme being accidentally started or a programme
in operation being accidentally changed. The child lock function locks all buttons and the
programme knob. The child lock can be activated or deactivated by holding down the
OPTION (3) and OK (4) buttons simultaneously for 5 seconds.
– Before programme is started: Appliance cannot be used
– After programme is started: Programme in operation cannot be changed
The
icon appears in the display to indicate that the child safety device is activated.
The child safety device is not deactivated once the programme comes to an end.
If you want to set a new programme, you must first deactivate the child safety device.
Starting the programme
Press the START PAUSE button (6). The programme is started.
The programme progress is shown in LCD by appropriate set of icons. From left to the right,
from iron dry
of cupboard dry programme the following status icons are visible:
cycle progress is marked by flashing dash under status icon. When appropriate part of drying
cycle is accomplished dash becomes steady and appears flashing under next status icon.
Changing programme
To change a programme which has been selected by mistake once the programme has
started, first turn the programme selector to OFF and then reset the programme.
for a programme of 20 minutes.
to anti-crease
icon depends on the drying cycle chosen. E. g. in case
if the programme is to be started in 12 hours.
15
Daily use
. Current
Advertisement
Table of Contents
