Onboard Control Menus - Martin MAC 101 User Manual

Onboard control menus

Menu
DMX ADDRESS
CONT MODE
PERSONALITY
FACTORY
SETTING
24
Item Options
1 – 501 (RAW/RGB)
1 – 505 (BASIC)
RAW
RGB
BASIC
P/T SPEED
SWAP
P/T SETTING
PAN INVERT
TILT INVERT
REGULATED
FANS
FULL
LINEAR
SQUARE LAW
DIMMER
INV SQUARE
CURVE
LAW
S-CURVE
FAST
DIMMER
SPEED
SMOOTH
OFF
DMX RESET
ON
ON
2MN
DISPLAY
5MN
10MN
DISPLAY
10-100
INTENSITY
NORMAL
ERROR MODE
SILENT
DISABLE
TOP HAT
ENABLE
FACTORY
LOAD
DEFAULT
Table 3: Control menu
MAC 101 user manual
Notes (Default settings in bold print)
DMX address (default address = 1). The DMX address
range is limited so that the fixture will always have
enough DMX channels in the 512 available.
RGB uncalibrated DMX control mode
RGB calibrated DMX control mode
Basic DMX control mode
Pan and tilt speed normal / fast / slow
Swap pan and tilt (pan commands move tilt and vice
versa) - off / on
Pan inversion (reverse direction pan control) - off / on
Tilt inversion (reverse direction tilt control) - off / on
Cooling fan speed thermostatically regulated
Max. cooling fan speed
Linear dimming curve
Square law dimming curve
Inverse square law dimming curve
S-curve dimming curve
Fast dimming with unrestricted speed
Smooth dimming with restricted speed
Disable reset via DMX
Enable reset via DMX
Display is always on
Display switches off and goes into Sleep mode if the
controls have not been pressed for 2 minutes.
Display switches off and goes into Sleep mode if the
controls have not been pressed for 5 minutes
Display switches off and goes into Sleep mode if the
controls have not been pressed for 10 minutes
Display intensity. Default=100
Display errors at 100% intensity (regardless of
DISPLAY INTENSITY setting) and illuminate the
service light
Silent error mode. The error message does not appear in
the display, but the service lamp is illuminated
No tilt limitation
Tilt limited by a few degrees to avoid collision between
top hat and base at maximum tilt – enable this setting
before installing a top hat
Return all settings (except calibrations) to factory
defaults
NB: can take up to 2 minutes to complete!