To Protect Operations With A Security Code - Sony MSU-1000 Operation Manual

The following settings can be configured.
[Auto Setup Enable]
add the [Auto Setup] button to the Maintenance menu.
The APR function of the control panel is permitted.
[Ref File Enable]
: Press this to light the button and permit
reference file configuration from the control panel.
[Lens File Enable]
: Press this to light the button and lens
file configuration from the control panel.
[OHB File Enable]
: Press this to light the button and
permit OHB file configuration from the control panel.
[Crop Enable]
: Press this to light the button and permit
16:9 c 4:3 Crop configuration from the control panel.
[Abs Enable]
: Press this to light the button and permit the
switching to the absolute value indication.
[Knee Max Enable]
permit knee max configuration from the control panel.
[3D Menu Enable]
: Press this to light the button and
permit 3D System and CCU 3D Monitor configuration
from the control panel. Light
using the HDFA-200 and configuring the 3D system.
[Custom Mtx Enable]
the Custom Matrix menu is added to the FILE menu.
You can save a Custom Preset Matrix file, and save or
readout the file from a Memory Stick.
3
[Exit]
Press when the settings are finished.
The Security screen reappears.
4
[Engineer Mode]
Press

To protect operations with a security code

To prevent unwanted operations, you can protect operation of
the control panel with a security code.
To enable security code protection
Under the default settings, the security code is disabled. Use
the following procedure to enable the security code.
1
Turn on the control panel while holding down the
PARA button, PANEL ACTIVE button, and camera
selection button 1.
MSU-1000
PARA
Holding
down
PANEL
ACTIVE
28
Settings
: Press this to light the button and
: Press this to light the button and
[3D Menu Enable]
: Press this to light the button and
to cancel engineer mode.
CABLE
MULTI
TALLY
ACTIVE
EXPAND
MSU-1500
Holding
down
The numeric keypad appears.
Engineer Protection
when
Code No:
OK
2
Use the numeric keypad to enter "0359," and then
[OK]
press .
The Engineer Protection screen appears.
Engineer Protection
Code
Enable
Code
Delete
3
[Code Enable]
Press
Security code protection is enabled.
[Code Delete]
If you press
confirmation screen for security code deletion appears.
The Engineer Protection screen reappears when you
[OK]
press .
4
[Exit]
Press .
To set the security code
Some of the menus on the control panel are operated in
engineer mode. To limit the use of engineer mode to specific
operators, preset the security code. After you set the security
code, it will need to be entered to switch to engineer mode.
DEG
SHUT
PARA EXPAND
PANEL
ACTIVE
MULTI/CABLE
TALLY
ACTIVE
MULTI/CABLE
TALLY
ACTIVE
NETWORK
7 8 9
4 5 6
1 2 3
0
Cancel
Exit
to light the button.
here to light the button, a