Sony MSU-1000 Operation Manual page 41

Paint menu
Menu Submenu
2/3
3/3
Skin DTL
Skin DTL 1
Switch Control item
Level Dep
Level Dep OFF
HD Adjust
H/V Ratio
Frequency
Mix Ratio
Detail Comb
HD Adjust
W Limiter
B Limiter
Fine DTL
Fine DTL
Knee Apt
Knee Apt
ON
Level
Phase
Width
Saturation
Auto Hue 1
Gate 1
Natural Skin DTL
Skin DTL 1
Description
Contour correction is not applied to the dark parts and S/N sensitivity is
increased in order to reduce the emphasizing of also the contours of noise
by the contour correction function. Adjusting this in the plus direction
results in contour correction not being applied up to a brighter level.
Disables the Level Dep function.
This is the second page of detail adjustment.
ON: Performs detail adjustment for HD output (down converted) of BPU.
OFF or not displayed: Performs the conventional detail adjustment.
Adjusts the horizontal and vertical ratio of contour correction.
Adjusts the center frequency of contour correction.
With a type of camera that creates a contour correction signal from
gamma, adjusts the ratio for adding that correction signal before and after
the gamma.
Reduces cross color noise by applying the comb filter to contour correction
signals. Adjusting this in the plus direction reduces cross color noise, but
resolution sensitivity deteriorates. This can only be used when an SD
camera is connected.
This is the third page of detail adjustment.
ON: Performs detail adjustment for HD output (down converted) of BPU.
OFF or not displayed: Performs the conventional detail adjustment.
This is the limiter correction for detail signals added in the white direction.
This is the limiter correction for detail signals added in the black direction.
Attenuates the contour correction signal. Adjusting this in the plus direction
attenuates the signal. This can only be used when an SD camera is
connected.
Enables the Fine DTL function. This can only be used when an SD camera
is connected.
Adjusts the resolution sensitivity of high-luminance parts for which knee is
applied.
Enables the Knee Apt function.
Allows adjustment of the contour correction level of the set color area. For
example, allows you to make the faces of people appear shiny.
Enables the Skin DTL function. Allows up to three channels to be adjusted
separately. This switch enables the Skin DTL function to be turned ON/OFF
simultaneously in accordance with the setting of each channel.
Sets the first channel of Skin DTL. When this channel is enabled, the ON
mark appears on the very left of the tab.
This is the contour correction value within the color area that is set with
Phase or Width. Adjusting this in the plus direction makes pictures sharp,
and adjusting this in the minus direction makes pictures soft. For cameras
with an electronic software focus function, this enables softer pictures than
when in the DTL OFF state.
Adjusts the center of the hues of the effective color area of Skin DTL. The
value is almost equivalent to the phase on a vector scope.
Sets a range centered on the phase. The value indicates an angle.
Disables Skin DTL for places with a small degree of color saturation.
Adjusting this in the minus direction lowers the degree of saturation at
which Skin DTL is disabled.
This is a function for automatically searching for a hue. Capture the subject
you want to measure in the center of the screen and execute the function.
The phase of this channel is adjusted automatically.
Adds a gate signal to the range of this channel for which Skin DTL is
effective. For the output connector for which the signal can be added, see
the manual of the corresponding device.
Enables the Natural Skin DTL function. This can be common to control the
three channels.
Enables Skin DTL of this channel. The first channel cannot be disabled.
41
Menus