To Perform Rpn Correction - Sony MSU-1000 Operation Manual

3
[Screen Saver]
Press
The Screen Saver screen appears.
Screen Saver
Screen Saver
ON
4
[ON]
Press to light the button and turn ON the screen
saver.
5
Press b or B of Wait Time to set the time until the
screen saver is activated in minutes.
6
Press b or B of Type to select the type of screen
saver.
[Preview]
Press to display a preview of the selected
screen saver. Press any place on the LCD to cancel the
preview display.

To perform RPN correction

The CCD image sensor is manufactured with high precision
technology. However, cosmic rays and other noise may affect
the pixels of the CCD image sensor, resulting in small white
dots appearing on the display. This is a physical characteristic
of CCD image sensors and is not a malfunction.
Performing auto black balance adjustment activates the
correction function, and may reduce the effects of this
phenomenon.
You can also perform correction manually to reduce the white
dots.
1
Enter engineer mode. (page 35)
2
Press the CONFIG button.
The menu closes and the control panel remains in
engineer mode.
3
Press the MAINTENANCE button.
The Maintenance screen appears.
Maintenance
Camera Lens
RPN
26
Settings
.
Exit
Preview
Wait Time
3 min
Type
Vertical Drawing
Engineer Mode Exit
SD
CCU VCS
Adjustings
4
[RPN]
Press .
The RPN Correction screen appears.
RPN Correction
R G
Cursor Indication
H/V
H Cursor V Cursor
Cursor
H Cursor V Cursor
500 157ev
A cross-shaped cursor appears on the PIX monitor.
Perform the following steps while viewing the PIX monitor.
5
Press the button that corresponds to the channel you
[R] [G]
want to correct ( ,
6
Select the cursor type displayed on the monitor.
[H Cursor]
: Press this to light the button and turn the
horizontal cursor ON.
[V Cursor]
: Press this to light the button and turn the
vertical cursor ON.
[H/V Cursor]
: Press this to light the button and turn the
horizontal and vertical cursors ON.
7
Move the cursors on the monitor to the position you
want to correct.
Turning the adjustment knobs move the cursors on the
monitor. Based on the cursor type selected in step 6, the
horizontal or vertical cursor or both will be assigned to the
adjustment knobs.
RPN Correction
R G
Cursor Indication
H/V
H Cursor V Cursor
Cursor
H Cursor V Cursor
500 157ev
Engineer Mode Exit
Enter
B
[B]
, or ) to light it.
Engineer Mode Exit
B Enter