To Set To Multi-Camera System (Mcs) Mode - Sony MSU-1000 Operation Manual

2 Set the IP address, Subnet mask, and Default
Gateway.
Press the corresponding input field, and then use the
numeric keypad on the screen to enter the information.
[Set]
3 Press .
12
[Exit]
Press .
The Network screen reappears and the control panel is
set to BRIDGE mode.

To set to multi-camera system (MCS) mode

Set the control panel to MCS mode when using it in a multi-
camera system on a LAN.
One device needs to be the master in MCS mode. The MSU
can be set as the master, but if there are multiple MSUs within
the system, set one MSU as the master and set the remaining
MSUs as clients.
To set the control panel to MCS mode, the TCP/IP, IP address
of the master device, and MSU number need to be set.
Configure the setting so that there will not be a duplicate within
the system.
1
Enter engineer mode. (page 35)
2
Display the MSU Config screen. (page 35)
MSU Config
Display
Customize
/Sound
Security
3
[Network]
Press .
The Network screen appears.
Network
Network
CNS
Info
22
Installation
Engineer Mode Exit
Mode Date/Time Network Information
Backup
Engineer Mode Exit
LAN I/F TCP/IP
4
[CNS]
Press .
The CNS screen appears.
Camera Network System
Legacy
Mode:Semi-Auto
Bridge
Target:0.0.0.0
Mode:Master
MCS
Master:0.0.0.0
MSU No.1
MSU
5
[MCS]
Press .
6
[Set]
Press .
The control panel is set to MCS mode.
7
Set the MCS mode to Master or Client and set the IP
address of the master device.
[Edit]
1 Press .
The MCS Mode Set screen appears.
MCS Mode Set
Master/Client
Master Client
Master
0_ 0 0
Set Cancel
2 To set to Master, press
[Client]
To set to Client, press
the IP address of the master device.
Press the IP address input field, and then use the numeric
keypad on the screen to enter the IP address.
[Set]
3 Press .
8
[Exit]
Press .
The CNS screen reappears.
9
Set the MSU number.
1 Turn the adjustment knob on the far left to change the
MSU number.
If an MSU number is set to 0 or a duplicate of that of
another MSU, the equipment will not function normally. Be
sure to set a number that will not be a duplicate of that of
another MSU.
[Set]
2 Press .
Engineer Mode Exit
Set
Edit Cancel
Edit
Engineer Mode Exit
7 8 9
4 5 6
1 2 3
0
BS 0 Enter
[Master]
of Master/Client.
of Master/Client then set