Table of Contents
Advertisement
Section 13: Linkage Installation
Step 24
Move the servo to the throttle open position using the
radio system. Manually move the throttle arm on the
carburetor to the open position. Use a 3mm set screw to
secure the throttle pushrod wire.
Section 14: Cowling Installation
Required Parts
• Fuselage assembly
• #4 x 5/8" sheet metal screw (4)
Required Tools and Adhesives
• Drill
• Hobby scissors
• Ruler
• Phillips screwdriver (small)
• Rotary tool with sanding drum
44
• Cowling
• Drill bit: 1/8", 3/32"
• 6-minute epoxy
• Hobby knife
Step 25
Check the movement of the throttle to verify there is no
binding at either low or high throttle. If there is, make the
necessary adjustment to eliminate any binding. Install the
throttle servo arm screw when complete.
Step 26
Use scrap wood to make a brace for the throttle pushrod
tube near the servo.
Step 1
Use a rotary tool, hobby scissors or hobby knife to
remove the material from the air intakes from the front of
the cowling.
Hide quick links:
Advertisement
Table of Contents
