Hangar 9 P-40 Warhawk Assembly Manual page 8

Section 1: Joining the Wing Halves

Step 11
Use masking tape to securely hold the wing panels
together. Allow the epoxy to fully cure before continuing to
the next section.

Step 12
Repeat Steps 1 through 11 for the remaining wing panel.

Step 13
Remove the covering at the trailing edge for the two
wing bolts. Center the wing bolt plate on the wing and
trace the placement of the plate onto the wing using a
felt-tipped pen.
8

Step 14
Remove the covering 1/16" inside the line drawn using a
sharp hobby knife. Remove the lines from the wing using
rubbing alcohol and a paper towel. Use medium CA to
glue the plate in position.

Step 15
Use a 1/4" drill bit and drill through the wing bolt place
for the wing bolts.