Installation; Installation Overview; Rear Panel Features - Extron electronics FOX T USW 203 User Manual

Installation

This section describes information for connecting and wiring the FOX T USW 203. Topics in
this section include:
•
•
•

Installation Overview

Follow these steps to install and set up an Extron FOX T USW 203 in a fiber optic system:
1.
2.
3.
4.

Rear Panel Features

A
B
C
D
E
Figure 2.
Installation Overview
Rear Panel Features
Connection Details
Turn off all of the equipment. Ensure that the video sources and output display are all
turned off and disconnected from the power source.
NOTE: For proper equipment cooling, do not stack units in a rack.
Mount the switcher (see Mounting
Connect the cables (see Rear Panel Features below).
Configure the switcher (see
Extenders Control Program
1
2
RGB/R-Y, Y, B-Y
POWER
12V
0.8 A MAX
3
LOOP-THRU
J A B
Analog video connector
Analog video loop-through
connector (see page 5)
HDMI input connectors
Audio input connector
HDMI switched output connector
(see page 5)
FOX T USW 203 Rear Panel Features
on page 38).
SIS Configuration and Control
on page 21).
INPUTS OUTPUTS
HDMI Tx
HDMI
AUDIO
OPTICAL
C D E
(see page 5) Fiber optic connector
F
RS-232 and Alarm Over Fiber
G
connector
(see page 5) Contact closure connector
H
(see page 5) Remote RS-232 connector
I
Power connector
J
FOX T USW 203 Universal Switcher • Installation
on page 13 or FOX
FOX T USW 203
Rx
REMOTE
RS-232
CONTACT
OVER FIBER ALARM
Tx Rx G 1 2 1 2 3 G
F G H
(see page 6)
(see page 6)
(see page 7)
(see page 7)
(see page 7)
RS-232
Tx Rx G
I
4