Removal Of The Carburetor Heater; The Carburettor And Its Components; Carburetor Overview - PEUGEOT SpeedFight 3 Workshop Manual

FUEL SYSTEM

Removal of the carburetor heater

- Remove the carburator warming resistor (1).
- Remove the heater earthing connection (2).
- Clean the carburettor body with Biosane
cleanser ref. 754748 or use an ultrasonic
cleaning tank.
- Blow into every jet and duct of the carburettor
body with compressed air.
Do not use any metal tool which
can damage the ducts of these
items.
- Re-install all the other components and, if
necessary, when starting the engine, readjust
according to the values indicated on the
technical data card.

The carburettor and its components

1. Choke.
2. Piston.
3. Sump.
4. Float.
5. Jets.
6. Needle valve.
7. Mixture screw.
8. Pick-up pump.
9. Idle screw.
10. Pick-up pump suction valve.
11. Deceleration enrichment device.
12. Carburetor heater.
54
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles
1
2
2
9
8a
11
5
8b
10
1
12
7
6
4
3