Checking the clutch linings
- Using the depth calliper, measure the
thickness of the clutch linings.
Mini. thickness 2 mm.
- Make sure surface of the plates in contact
with the belt does not show any cracks or
signs of abnormal wear.
Replacing the clutch lining assembly
- Compress the clutch drive pulley and driven
pulley assembly with the tool P/N 752127
clamped in the jaws of a vice.
- Remove nut (1) using spanner P/N 752361.
- Slacken tool P/N 752127.
Tightening torque: 55 Nm.
- Remove the clutch lining assembly (2).
- When re-installing the driven pulley,
lubricate the needle bearing (3).
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles
A
B
752127
2
SERVICE OPERATIONS
1
3
31